Lippert-components CA-FU Manuel d'utilisateur télécharger pdf

Model: CA-FU

1967-1972 Chevrolet/GMC Installation

1. Remove the two bolts on each side of the front truck panel (as

shown in Fig. 1).

2. Insert the front Anchor Plate (Fig. 2). Secure with the same bolts

removed. Use the smaller (5/16”) holes in the front Anchor

Plate. The 3/8” bolts provided fit another truck model and may

be discarded.

1. Making certain of correct hole position for your truck model (see

Fig. 3), mark and drill bottom hole (to prevent drill from drift-

ing, drill small pilot hole first and then enlarge to 3/8”). Connect

Anchor Plate (Fig. 2) with lower bolt prior to drilling top hole.

2. Rotate Anchor Plate slightly outward so the plate threads are not

damaged while drilling top hole.

3. With tightened lower bolt to hold guide strap firmly in place, drill

top hole* (drill small pilot hole first and enlarge to 3/8”).

4. Loosen bottom bolt to allow top bolt to start easily, then tighten

bolts.

* When stake pocket prevents top hole from being drilled at straight

angle, drill hole at the best angle permissible. The hole angle

can easily be straightened to 90º by placing the 3/8” section of

rod (included for this purpose) through the hole and tapping it

with a hammer in the direction needed to straighten the hole.

FFRONTRONT A ANCHORNCHOR I INSTALLATIONNSTALLATION

RREAREAR A ANCHORNCHOR I INSTALLATIONNSTALLATION

1. Locate universal rear anchor such that the alignment is as nearly vertical below the camper eye-bolt as possible,

and low enough to allow sufficient space between eye-bolt and rear anchor for turnbuckle installation (generally

13”-18”). WARNING: Before drilling check for clear access to the backside between outer fender and bed wall,

and check for any wires, fuel lines, etc.

2. Drill small pilot hole and enlarge to 1/2”.

3. Tightly secure chrome anchor bolt with large fender washer, lock-washer, and nut (Fig. 4)

4. Removable Tiedown Coupler connects turnbuckle to anchor.

Customer Service Numbers:

Web: www.happijac.com

Phone: (800) 231-7440

(801) 544-2585

Fax: (801) 546-5241

Email:

[email protected]

1972-1993 Dodge D-Series (1991-1993 require FK-DAK)

1966-1979 Ford F-Series (except 1979 F350 w/side tire)

1967-1972 Chev/GMC C/K Series

inscafu110403

Model: CA-FU 1

Résumé du contenu

Page 1 - Model: CA-FU

Model: CA-FU 1967-1972 Chevrolet/GMC Installation 1. Remove the two bolts on each side of the front truck panel (as shown in Fig. 1). 2. Insert the f

Commentaires sur ces manuels

Pas de commentaire

Lippert-components CA-FU Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Lippert-components CA-FU. Lippert Components CA-FU User Manual [de] [fr] [it] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Lippert-components CA-FU