Lippert-components In Wall Slide-Out System Manuel d'utilisateur télécharger pdf (Page 12)

8. The motor can now be installed. Insert the motor through the top of the side column. Note the

screws protruding from the shaft end of the motor. They enter into the 2 holes in the corners of

the motor mount. Pay attention to the orientation of the screws and mating holes.

9. Align the motor shaft with the hole in the coupler, the motor should drop part of the way into the

coupler. While pushing down on the motor, slide the side column back and forth on the racks to

rotatethecouplerandalignthecoupleratwiththeatonthemotorshaft.Whentheatslineup, 

the motor will drop down onto the motor mount.

10. Replace the motor retention screw.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Lippert-components In Wall Slide-Out System Manuel d'utilisateur Page 12