Lippert-components In Wall Slide-Out System Manuel d'utilisateur télécharger pdf (Page 3)

1-2 Motor wiring harness connections

NOTE: Ribs on motor connector line up with notch in side of male connector on wiring harness.

Color codes on wires also match (black to black, red to red, etc.).

1-3 Extend and retract switch connections

NOTE: Direction control switch (customer supplied)

Common connection on control board goes to common connection on extend and retract switch. The

extend and retract connections on the control board go to the extend and retract terminals on the

switch. Power is supplied to switch from any nearby 12VDC power source.

Correctly connected motor

1-4 Power to board

¼ spade terminals are provided for power into the board. (Voltage range 8vdc to 18vdc).12 vdc is

recommended. Lower voltages reduce available power to room slide. 10ga wire is the minimum size

recommended.

1-5 Board overview

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

Lippert-components In Wall Slide-Out System Manuel d'utilisateur Page 3